0

Out of 0 Ratings

Owner's of the Cisco Systems Switch Cisco Nexus Switch gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 204
 
Send document comments to nexus7k-docfeedback@cisco.com
D-2
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Appendix D Repacking the Cisco Nexus 7000 Series Device for Shipment
Repacking the System Components
Disconnecting the System from the Network
To disconnect the system from the network, you must remove each I/O cable from the system I/O
modules.
Repacking the System Components
You should repack the Cisco Nexus 7000 Series system in the packing materials in which it was
originally shipped. To make the Cisco Nexus 7000 Series lighter and easier to move, remove its power
supply units and its optional features, such as the midframe doors, lower frame, and air filter. You should
pack each of these components separately. Using a mechanical lift, move the chassis from the rack to its
shipping pallet and complete the packaging for shipment.
This section includes the following topics:
Prerequisites for Repacking the System, page D-2
Required Tools and Equipment for Repacking the System, page D-2
Repacking the Cisco Nexus 7010 Device, page D-3
Prerequisites for Repacking the System
You must disconnect the system from the network and power it down before you begin removing it from
the rack or cabinet.
Required Tools and Equipment for Repacking the System
Before you repack the Cisco Nexus 7000 Series chassis into the original shipping materials, make sure
that you have the following tools and equipment:
Mechanical lift capable of lifting 500 lbs (227 kg)
No. 1 Phillips screwdriver with torque capability
3/16-inch flat-blade screwdriver
ESD wrist strap
Original shipping container and packing materials:
Two pallets (typically with the smaller pallet bolted on top of the larger pallet)
4 angle brackets with 8 bolts and 16 screws
Ployethylene cushion
2 three-segment dividers
3 power supply boxes
2 J-box sides
1 lid
6 corro clips
Strapping