0
Owner's of the Whirlpool Clothes Dryer 4LEC7646EN0 gave it a score of 0 out of 5. Here's how the scores stacked up:
Check that you have everything necessary for
correct installation. Proper installation is your
responsibility.
Tools needed for installation:
socket wrench
1 screwdriver
nut driver (shown)
or socket wrench
gun and compound illips
ewdriver
Tools needed to change door swing:
l
Phillips screwdriver
l
soft cloth or towel
1 Parts supplied for installation:
I
Remove parts package from dryer drum. Check that
all parts were included.
4 leveling legs
Part No. 3397625
0 1996 Whirlpool Corporation
1 Parts needed for installation:
Check local codes and see electrical and venting requirements, Panels A and B, before purchasing parts.
Determine if you will need to purchase a power supply cord kit or power supply cable.
Electrical
If using a power supply cord:
Ductwork
Dryer power supply cord must be:
l
U.L.-listed
Four-inch (10.2 cm) metal exhaust vent must be
used.
l
220~volt minimum
l
30-ampere
l
Type SRD or SRDT
l
At least 4 feet (122 cm) long
The wires that connect to the dryer must end in
ring terminals or spade terminals with upturned
ends.
0
@
4-wire rece tacle
(l4-30l5
IL
0
\8
3-wire rece
If
tacle
(10-30 )
4-wire power supply cord with
ring or spade terminals and
U.L.-listed strain relief
L
If connecting by direct wire:
Power supply cable must match power supply
(4-wire or 3-wire) and be:
l
flexible armored or non-metallic sheathed
copper cable (with grounding wire).
l
lo-GAUGE SOLID COPPER WIRE. (Do not use
aluminum.)
Venting
No flexible plastic
No flexible foil
Exhaust hood
Do Not use exhaust hoods with magnetic latches.
Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022
Non-exhausted recessed installations:
require Exhaust Deflector Kit, Part Number 3391278*
Floors sloped greater than 1 inch (2.5 cm):
require Extended Dryer Feet Kit, Part No. 27981 O*
*Available for purchase from your dealer.
Printed in U.S.A.
Find Your Products By Category
Please Login
