0

Out of 0 Ratings

Owner's of the 3Com Gas Grill SMART Mobile Stand for Interactive Displays gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 104
 
99-00962-20 REV C0
11 | ASSEMBLING YOUR SMART MOBILE STAND
Things to Consider When Assembling Your
SMART Mobile Stand
WARNING
Two people are required to safely assemble your SMART Mobile Stand
and to mount or remove your flat-panel display and your SMART Board
interactive display frame or SMART Board for Flat-Panel Displays
interactive overlay.
Lock the casters before installing or working with your flat-panel display
on your SMART Mobile Stand, or adjusting its height.
To prevent injury, be aware of crush and pinch locations on the product
(marked with the crush symbol) during assembly and use.
Do not rest your hand on the stand’s universal mount or under the interactive
product’s pen tray or pencil ledge while adjusting the height of your
SMART Mobile Stand.
Use the SMART Mobile Stand’s three grab bars to move the unit.
Do not press, pull or push on the flat-panel display, interactive overlay
or display frame, cabinet, doors, rear access panel plastics or
vertical brackets.
Before moving your SMART Mobile Stand, make sure that you unlock the
casters. These casters are designed to roll on common indoor surfaces.
While you move the unit, your view may be partially obstructed.
Be aware of surrounding obstacles.
CAUTION
To prevent damage to your power and extender cables, secure them to your
mobile floor stand as instructed in the SMART Mobile Stand for Interactive
Displays Textless Installation Instructions (document 132293
at www.smarttech.com/support
).
NOTES
You will require ample work space to assemble your SMART Mobile Stand.
Do not set up or use your SMART Mobile Stand in an area with excessive
levels of dust, dirt, humidity or smoke.
If you received an IEC power bar with your SMART Mobile Stand and you
need to ground this power bar, use a self-tapping screw (not included)
to secure its ground wire to the base sheet metal of your stand. Use the small
hole located on the right side of the power bar (when viewed from the back)
for this purpose.