0

Out of 0 Ratings

Owner's of the A.O. Smith Boiler 3400 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 83
 
60
CONFIGURATION
The Burner Control can be congured from the OI Display. The
control conguration is grouped into the functional groups as
shown in Table 23.
HYDRONIC CONTROL
System Identication and
Access
CH - Central Heat
Outdoor Reset
DHW - Domestic Hot Water
DHW Storage
DHW Plate
Warm Weather Shutdown
Demand Priority
Modulation Conguration
Pump Conguration
Statistics Conguration
High Limit
Stack Limit
Delta T Limits
T-Rise Limit
Heat Exchanger High Limit
Anti-condensation
Frost Protection Conguration
Annunciation Conguration
Burner Control Interlocks
Burner Control Timings and Rates
Burner Control Ignition
Burner Control Flame Failure
System Conguration
Fan Conguration
Sensor Conguration
Lead Lag Slave Conguration
Lead Lag Master Conguration
Most of this conguration is performed by the Service Agent
or at A.O. Smith. Each functional group is displayed on the
Conguration menu page.
Parameters in functional groups that are not applicable for
the installation can be ignored. In some cases, features in a
functional group are disabled by default and are enabled when
needed for the installation.
SYSTEM SYNCHRONIZATION (S7999B OI DISPLAY ONLY)
The user can manually synchronize conguration data from the
connected controls at any time.
A new control is visible when conguration and status data is
gathered from it. This collection procedure takes a few minutes.
The control is marked as “Unknown” when no conguration
information exists. Normally, control conguration data collection
only needs to be performed when the control is initially installed.
However, a re synchronization is necessary after the OI Display
is reset. See Figure 76.
The user presses the Synchronize button to begin synchronization
with the control. See Figure 76.
Status of the synchronization is reected in the dialog box. The
synchronization can be aborted by selecting the Cancel button.
FIGURE 76. SYSTEM SYNCHRONIZATION
TABLE 23. FUNCTIONAL CONFIGURATION GROUPS