3.0

Out of 1 Ratings

Owner's of the A.O. Smith Boiler 1700 gave it a score of 3.0 out of 5. Here's how the scores stacked up:
  • Reliability

    3.0 out of 5
  • Durability

    3.0 out of 5
  • Maintenance

    3.0 out of 5
  • Performance

    3.0 out of 5
  • Ease of Use

    3.0 out of 5
of 83
 
55
Note: When the installer proceeds with the safety parameter
conguration, the control unlocks the safety parameters in this
group and marks them unusable. Failure to complete the entire
safety conguration procedure leaves the control in an un-
runnable state (lockout 2).
All safety conguration parameters in the group should have the
same access level. If this condition isn’t so, the user is asked to
enter another password when a higher access level is needed.
Successful login is noted by the lock icon, which changes
to “unlocked” on the page. The installer may begin to change
safety parameters (or any other parameters) at that time (see
Figure 61). If the Burner Control is in an uncongured (or new)
state, then this warning doesn’t appear. All parameters that need
changes should be changed during the login.
If the safety conguration session is terminated after it has
started (in the Edit or Verify stages), the Burner Control is left in
an uncongured (unrunnable) state.
The installer can terminate the session by pressing the Menu
button or by attempting to leave the Verication page with
the Home or Back buttons (top-left and -right screen corners,
respectively). However, leaving the session at this point leaves
the control in an unrunnable state and conrms whether the
installer still wants to do so.
The settings of all parameters in each safety block must be
veried to save them in the control.
When the installer is done changing safety parameters,
pressing the Verify button on the conguration screen begins
the Verication process. The settings for all safety parameters
in each changed block are presented and Veried by the installer
(see Figure 62 on Page 56).
VERIFY
Pressing the Verify button displays safety conguration
parameters for an additional verication step to commit the
changes.
Safety parameters are grouped into blocks that include only
safety parameters, not a mixture of safety data and non-safety
data. All parameters within the safety group undergo a verication
process. A safety parameter group is identied on the display to
indicate when the conguration parameters are safety-related.
Each safety parameter group is veried one at a time until all
have been veried. See Figure 60.
Like operating parameters, safety parameters can be viewed
without the need to enter a password.
Safety parameter blocks that have been changed require
verication. The verication steps do not have to be completed
immediately; the installer can move between and change
parameter groups before the verication is done. A Verify button
is enabled that allows the installer to conduct verication sessions
(the example of the Verify button in Figure 55 is not yet enabled
because the installer hasn’t logged in).
FIGURE 59. EXAMPLE OF CHANGE CONFIGURATION
PARAMETER PAGE
FIGURE 60. SAFETY VERIFICATION
FIGURE 61. EDIT SAFETY DATA