0

Out of 0 Ratings

Owner's of the 3D Innovations Gas Grill COOKER HOB VITROLINE HI-LIGHT gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 15
 
25
The worktop must be completely level.
Protect the cut-out surfaces.
Screw on the support elements provided using the respective
screws on the front and rear end of the cooker hob (already
configured with the relative holes and slots).
Connect the cooker hob to the mains electricity (consult the
connection instructions).
Position the cooker hob in the cut-out.
Press it forcefully agianst the worktop.
Applying the sealant
The picture indicates how the sealant must be applied along the entire edge.
CONNECTION TO THE MAINS ELECTRICITY
The electrical connections must be carried out by qualified personnel only. The electrical
connection must be protected in accordance with the regulations in force.
The connectors are accessible when the wires cover is opened.
Prior to connecting the appliance, verify that the voltage indicated on the rating plate complies
with the mains voltage.
The rating plate of the glass-ceramic hob is located on the underside.
The appliance operates at 220-240V AC ~ (or, alternatively, at 380-415 V 2N~).
In the direct connection to the mains electricity, an omnipolar switch with a contact gap of 3 mm -
suitably sized for the load and conforming to the regulations in force - is positioned between the
appliance and the power outlet.
The type of electrical connection must be chosen according to the available installation options for
the electric current and overload safety switches.
To ensure protection against fire, appliances of this kind can be installed between a taller cabinet
on one side and a cabinet of equal height (as the appliance) on the other side.
For safety reasons, electrical connection components and insulated parts must not be accessible.
If the model is not equipped with a plug, mount a standardised plug on the power cord capable of
withstanding the load indicated on the rating plate. The earth wire is identified by the
yellow/green jacket. The plug must always be accessible.
After each connection to the mains electricity, basic configuration of the
sensors must be carried out to ensure their optimal operation. All the
displays turn on for a few seconds. There must be no objects on the hob
surface during sensor configuration. Otherwise, the configuration
Installation procedure
Basic
configuration of
the sensors to
the environment
(for model "7316-000"
only)