0

Out of 0 Ratings

Owner's of the KitchenAid Mixer KSM7586PSR gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 68
 
7
English
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
WARNING
To Attach Bowl
1. Be sure speed control is OFF
and Stand Mixer is unplugged.
2. Place bowl-lift lever in down
position.
3. Fit bowl supports over locating
pins.
4. Press down on back of bowl
until bowl pin snaps into spring
latch.
5. Raise bowl before mixing.
6. Plug into a grounded 3 prong
outlet.
To Raise Bowl
1. Rotate lever to straight-up
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate lever back and down.
To Remove Bowl
1. Be sure speed control is OFF and
Stand Mixer is unplugged.
2. Place bowl-lift lever in down
position.
3. Remove at beater, wire whip,
or spiral dough hook.
4. Grasp bowl handle and lift straight
up and off locating pins.
To Attach Flat Beater, Wire Whip,
or PowerKnead™ Spiral Dough Hook
1. Slide speed control to OFF
and unplug.
2. Slip at beater on beater shaft.
3. Turn beater to right, hooking
beater over the pin on shaft.
4. Plug into a grounded 3 prong outlet.
To Remove Flat Beater, Wire Whip,
or PowerKnead™ Spiral Dough Hook
1. Slide speed control to OFF
and unplug.
2. Press beater upward and turn to
the left.
3. Pull beater from beater shaft.
Household Stand Mixer
Speed Control
Plug into a grounded 3 prong outlet.
Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of bowl.
See the “Speed Control Guide” section.
Pin
Assembling Your Bowl-Lift Stand Mixer
W10505976A_EN.indd 7 8/22/12 12:37 PM